05/17/2017 Note to the hostess
For most girls, the word “fur” immediately evokes an association with a luxurious white fur coat - or at least a voluminous and fluffy collar, but a white one. That's right, such products look very rich and luxurious. However, they require constant and very special care when it comes to natural fur.
How to clean white fur at home is not an idle question, since such products get dirty very quickly. A careless wave of the hand, a turn of the head - and on the fibers there is already a colorful palette of foundation, powder, blush and lipstick. And his fur turns yellow from his favorite perfume - he hates it, unlike you.
It may turn yellow just like that, even after lying in the closet for several months. Taking it to the dry cleaner every time you don’t like the appearance of a fur product is expensive and troublesome. Is it possible to deal with the problem on your own? Certainly! And it will cost much less.
Dry bleaching
This cleaning method uses simple dry substances, most of which are found in the kitchen or home medicine cabinet.
Semolina
An effective and inexpensive way to remove yellowness from fur is to take simple semolina, which can be no less effective than expensive chemicals.
It needs to be scattered onto the pile and rubbed lightly into the surface of the fur until the grain becomes dirty and the fur, on the contrary, becomes clean and shiny. Remains of semolina can be removed by vigorously shaking the item or gently vacuuming it.
In a similar way, it is easy to clean a fur hat from yellowness and grease.
Gasoline based mixtures
You can clean white mink from yellowness if you use a mixture of high-quality gasoline and potato starch. They must be mixed in such a proportion that a mass with the consistency of thick sour cream is obtained. The mixture should be applied with a rag or brush in a thin layer to dirty, yellowed, greasy areas and left until the mixture is completely dry. It must be removed and the product hung in fresh air to ventilate from gasoline vapors.
In the same way, you can try to bleach the yellowness of arctic fox fur.
An original way to clean white fur products is to treat the natural pile with special sawdust, which is used for keeping animals. They need to be soaked in a small amount of good gasoline, sprinkled on contaminated surfaces, left for about 1 hour, and then simply shaken off and combed with a wide-tooth comb.
Wheat bran
Blue mink coats are the easiest to clean with bran. They need to be slightly dried and heated in a frying pan without fat.
Place the product on the table, cover it with a sufficient amount of bran and distribute it evenly over the pile. When they absorb dirt and grease, you need to carefully remove the flakes from the surface and carefully shake off the fur coat from product residues.
Talc and chalk are combed out with a comb
If you want to clean white fur at home, you can treat it with talcum powder or chalk.
Talc can be purchased at a pharmacy; it is advisable to take one that does not have a strong foreign odor. The most ordinary chalk will be useful - it must be crushed with improvised objects and be sure to sift.
The contaminated product should be laid out on a flat surface, carefully sprinkle talcum powder or chalk over the entire surface and lightly rub in with your hands. Due to their porous structure, these substances easily absorb dirt and grease.
After some time, you will need to carefully comb out the dry substances from the pile using a brush or a wide-toothed comb. Long fur should be brushed in the direction of the hair growth, while short fur should be brushed against the grain.
At the final stage, it is advisable to get rid of any remaining chalk or talc by simply vacuuming the product or brushing it with a brush.
Advantages of a white mink fur coat
Most girls prefer a light-colored fur coat. It is in it that the female silhouette looks graceful, attractive and alluring. Thanks to it, you can create amazing images for everyday life or special occasions. Mink models of any shade look very beautiful, but white is the height of perfection. It makes its owner a real queen.
White mink does not leave the catwalks, constantly appearing in the collections of world famous brands. Snow-white luxurious fur sparkles and shines under the spotlights, hypnotizing viewers with its purity and sophistication. This is the only color that does not have shade transitions from light to dark. Large monochrome canvases are created from such skins, and delightful models of the most incredible styles are sewn.
Designers successfully use white mink fur for sewing products in combination with laser cutting, perforation, and the “paws” effect. In this case, fur coats are obtained with beautiful patterns of pile of different heights. Snow-white mink outerwear is unique and rare; more often you can find shades close to beige. These are “pearl” and “topaz”. It doesn’t matter whether you choose a long or short white fur coat - you will look solemn, feminine and seductive in it.
Advantages of white mink coats:
- quite rare, original color;
- density and thickness of the pile;
- many styles and models;
- allow you to create unique images;
- warm, light;
- with shiny, iridescent pile;
- Can be combined with clothes of any tones and styles.
Wet methods for removing yellowness
When using various liquids for cleaning, it is important to remember that furs do not like moisture, so the use of cleaning products should be as short-term as possible.
You cannot dry fur coats, hats and sheepskin coats using electrical appliances and heating radiators - this will lead to rapid damage to the products.
Before using chemicals on the entire surface of the fur, it is necessary to make a control test on a small area in an inconspicuous place. If the pile has not been deformed, you can begin dry cleaning at home.
Hydrogen peroxide and ammonia
If the fur coat has turned yellow only in a few places, for example, in the collar area, you can treat this area with a mixture of simple medications available in every pharmacy. In 1 glass of cool boiled water you need to dissolve 1 tsp. 3% hydrogen peroxide and add a few drops of ammonia.
The resulting solution must be poured into a spray bottle, irrigate the problem areas and dry in natural conditions, preferably in bright sun, to enhance the effect of the peroxide. After this treatment, the pile will acquire its original appearance.
Soap solution
You can try to clean fur that has lost its whiteness with a soap solution. To do this, you need to grate laundry or baby soap, dissolve it in water and beat it into a thick foam. Apply it to the surface of the pile and lightly wipe.
After the procedure, you need to dry the product and comb it with a sparse comb.
You can also use liquid soap, the main thing is that it does not contain aggressive dyes that can change the color of the fur, or artificial fragrances.
Blue
Blue mink products can be easily cleaned with blue mink. It is necessary to prepare an aqueous solution, but so that it acquires only a barely noticeable blueness, and irrigate the yellowed areas with a spray bottle.
It is important not to overdo it with adding powder, as you can hopelessly ruin the entire product.
In the same way, you can easily clean silver fox fur from yellowness.
Alcohol and salt
Ordinary salt mixed with alcohol can restore whiteness to white fur items. It is recommended to dilute 3 parts salt in 1 part alcohol, mix and add 1 glass of warm water.
Use a clean sponge or cotton swab soaked in this solution to thoroughly treat the contaminated areas. Afterwards, dry the product in the open air.
Vinegar with lemon juice
To rid light fur of yellowness, it is recommended to use 9% table vinegar. You need to stir 1 tbsp. l. acid in 1 glass of lukewarm water and, moistening a cotton pad in the resulting mixture, wipe the dirty and yellowed areas, moving in the direction of hair growth. Treated clothing should be air dried to get rid of the specific vinegar smell.
Lemon juice has good lightening properties. It can be used to bleach faux white fur. The juice must be mixed with water in equal parts and applied to problem areas using a spray bottle. The product should be dried in a place with good ventilation.
Instead of natural juice, you can take citric acid, dissolving it in water in a small amount.
This method is suitable for bleaching faux fur.
How to get rid of grease stains
If for some reason grease stains appear on a fur item, experts recommend using aviation gasoline rather than regular gasoline to remove it.
You need to apply a little fuel to the sponge and carefully treat the stains. It does not matter what kind of fur is cleaned, artificial or natural. Gasoline should be applied carefully as the pile grows. After this method of getting rid of grease stains, it is advisable to hang the clothes out in the open air and wait until the smell of gasoline disappears completely.
Clean a fur coat at home (Principles of fur cleaning)
Stains and yellowness appear visually, but other types of dirt can be determined by a stream of cold air from a hairdryer. If the fur is clean, the fibers will fly away and then easily return to their place. Grease, deformed areas, saws, dirt, other stains - such areas need to be noted and cleaned.
Fur should not be washed to avoid deformation and baldness. It is also prohibited:
- Dry with a hairdryer.
- Place the product near heating appliances.
- Dry under ultraviolet light.
- Only outdoors, in a boiled room.
- In winter - at room temperature, away from the battery.
- There is a taboo on ironing, even on the reverse side.
- It is not recommended to use aggressive household chemicals and chlorine-containing bleaches.
Mechanical cleaning methods are aimed at removing lumps, hair knots, dust, and dirt. At home, abrasive materials such as starch, semolina, chalk, talc, sand are used, which are used for grinding and polishing delicate items.
Chemical technologies dissolve grease, paint, and outdated dirt. Their action is aimed at restoring the silkiness of the pile, increasing the strength and elasticity of the skin base.
These methods should absolutely not be used
Despite the variety of methods that are recommended for ridding furs of dirt and yellowness, some methods can render things unusable.
In the process of returning whiteness to natural fur items, when wet methods are used, you need to ensure that only the pile is processed and try not to wet the inner layer - the leather base to which the hairs are attached. This may result in damage to the product.
You cannot wash natural fur items in water - the core on which the lint is held will become stiff, the lint may fall out, and such items will no longer be worn.
You need to use gasoline with caution - not all furs tolerate its effects well. Before total cleaning, it is recommended to test the effect of products prepared on its basis in an inconspicuous place.
Causes of yellowing
This problem occurs with both natural and artificial fur coats.
A fur product begins to turn yellow for several reasons:
- settling of a large amount of dust;
- temperature changes;
- contact with perfume;
- wearing a fur product in wet weather.
To ensure that your favorite white fur coat does not lose its luxurious appearance, it is recommended to regularly clean it and follow the rules of care and storage of the product recommended by the manufacturer. If the fur does turn yellow, you can return it to whiteness yourself at home.
Some tips for caring for white fur
White fur, regardless of origin (both natural and artificial), requires constant careful care, as it quickly loses its attractive appearance due to its soiling.
Therefore, when wearing fur products, you must follow a few simple rules:
- In the spring, at the end of the winter season, before storing your fur coat or hat, you need to clean it of street dirt by wiping it with a clean sponge soaked in a solution of 9% vinegar and water. After this, things need to be air dried.
- Fur items should be stored in a linen bag or wrapped in blue paper so that they cannot turn yellow.
- It is important to take care of keeping things moth-proof. Fresh and dry geranium leaves, orange peels or tobacco, placed in fabric bags in the closet, can help with this.
- Yellowness often appears under the influence of moisture, therefore, if the fur gets wet under snow or rain, it must be immediately vigorously shaken off and dried naturally.
- In the summer, you need to remember to air your fur coats and hats on the balcony from time to time, and also comb the fur so that it does not lose its shape and fluffiness.
If you follow these simple recommendations, white fur items will always retain their original appearance, and you will have to clean them from dirt, grease and yellowness much less often.
Rules for choosing a snow-white mink fur coat
In order not to be upset about a fur coat that quickly deteriorates, you need to choose the right quality model. An unscrupulous seller can easily sell rabbit fur under the guise of sheared mink. You should not purchase things from unverified companies.
The Russian factory Diana Furs produces outerwear from premium mink fur. By purchasing our products, you can be sure that they will retain their original appearance, softness and shine for a long time. An item made by the best specialists undergoes strict control and receives a certificate confirming its quality.
What to look for when choosing:
- the fur cannot be matted, have different lengths or lie unevenly;
- the pile should not be sewn to the lining or get into the seams;
- the parts are sewn together in strips of the same length;
- the pile holds tightly and does not come out in clumps;
- the lining is not sewn “tightly”;
- The color of the pile is uniform, as “cold” and snow-white as possible.
