You can achieve your goal by immersing the cover in hot water. Next, the overlay is placed on a pre-prepared wooden model, the dimensions of which correspond to the desired stretching result. After putting on the cover, it is warmed up again in water for 60 minutes and cooled at room temperature. Now you can remove the cover from the block, wipe it dry with a rag and try to try it on your phone. The presented methods will help to cope with the problem of a small case if its size needs to be increased by 1-3 mm.
Preparatory actions
When considering how to reduce the size of a silicone phone case, you can use a simple technique. It involves heat treating the bumper. If it is impossible to return the accessory to the store, you should try to reduce its size using regular boiling water.
Various techniques are used to narrow the cover. Some buyers advise using alcohol or acetone, a freezer or a hair dryer. One of the most adequate methods is the one that uses boiling water.
You will need two pans. They should be larger than the case itself. The first container should contain hot water, and the second should contain cold water. You need to make sure that there are no foreign impurities in the water so that the cover does not change color. It is also worth considering that it is better to carry out such a procedure with an opaque cover. Otherwise it will become dull.
It is better to add a lot of ice to a container of cold water. It is necessary to create a maximum temperature contrast during the processing of the cover.
Features of the procedure
Is it possible to shrink a silicone phone case at home? Buyers of low-quality products face this issue. A good smartphone case will not stretch even after several years of active use. When purchasing cheap products, you should expect changes in the dimensions of the protective bumper.
When wondering how to shrink a silicone phone case, it’s worth noting that they all react to heat treatment differently. It is not always possible to reduce the bumper at home. But, nevertheless, it's worth a try. The result depends on what material the case is made of. They are made from silicone with different component compositions. Today, many variations of materials are used.
It was successfully possible to shrink a case made of TPU (thermoplastic polyurethane). The vast majority of bumpers are made from it. When heat treated, the material shrinks. But it’s hard to predict how a case will behave during heat treatment from a different silicone-based composition.
How to solve the problem of enlarging the case
As for tips on how to stretch a leatherette phone case, slightly different approaches are used here. We all know that skin tends to stretch. Good leatherette also provides similar opportunities. By analogy with natural material, you can try to stretch the case by inserting a model of your device into it, for example, made of wood. First, the base must be split in half, installing a spacer in the center, which will increase the capacity of the case.
Experts advise placing this entire structure in warm water and leaving it for a while. After the spacer is removed and the case is dry, it should acquire a new desired shape that will allow it to be easily installed on the gadget.
Do not forget that before trying this method, you should, again, contact the seller and tell him your complaints regarding the defects of the ordered product.
How to make a phone case from a balloon
The technique for creating such a bumper is similar to vacuum packaging a phone in latex.
- The balloon is inflated to medium size.
- It must be laid on a flat surface, holding the neck with two fingers.
- Place the phone in the middle.
- The gadget must be slightly pressed down and the air must be released from the ball.
- A couple of minutes of work, and the phone is dressed in a new bright shirt.
- All that remains is to cut holes for the camera and connectors, and the thin material will not interfere with the operation of the buttons.
The technique for creating such a bumper is similar to vacuum packaging a phone in latex.
Result
Having considered the procedure for how to shrink a silicone phone case, you need to take into account several nuances. Using this method, you can reduce the size of the accessory by just a few millimeters. If it is significantly larger than a smartphone, it will not be possible to reduce it at home. In this case, it is easier to buy a new bumper.
You should be prepared for the fact that the material may change shade and become matte. There may also be deformations that will need to be adjusted manually while the case is still warm.
Over time, the case stretches and moves around the iPhone 7
But the saddest thing about this accessory is its fragility .
In addition, I have a couple more cases for the iPhone 7, which I change according to my mood and depending on the specific situation - we’ve already talked about one armor-piercing one, and we’ll look at another one a little later.
And due to regular putting on and taking off, the official Apple case has stretched and now does not fit as tightly to the device as it did before. And in the area of the camera, which is partially visible in the photograph, he is generally shaking.
As a result: I highly do not recommend it - a waste of money and nerves.
Post rating:
( 4.13 out of 5, rated: 8)
Comments
The desire to decorate your phone arises in everyone who enters cellular communication centers at the sight of attractive cases and bumpers. But not all of them can provide the communication device with adequate protection in the event of an impact or fall. And if the range includes a shock-absorbing bumper for your phone, it will either not be suitable for your model, or its cost will be astronomical. There is only one way out - to spend a little time, imagination, effort and make a beautiful case from scrap materials.
Everyone has a desire to decorate their phone.
The colorful bumper can be made from silicone to make molds without touching brushes or glue.
To prepare the material you will need:
- Construction silicone;
- Potato starch as a thickener and to give white color;
- Color or acrylic paint.
It is better to use silicone gloves during the kneading process. This way your hands will feel the material, and you won’t have to wash them for a long time.
Manufacturing technology:
- After squeezing out the silicone, you need to add two tablespoons of potato starch to it.
- The process of kneading silicone “dough” is similar to the preparatory stage before modeling from plasticine. It needs to be kneaded until the mass becomes homogeneous.
- If you divide the resulting mass into several almost equal pieces and add a color to each of them, you will get multi-colored balls. They need to be flattened, folded so that each previous one peeks out from under the previous cake by a few millimeters.
- Using a rolling pin, roll out the workpiece so that it is enough to cover the back wall of the gadget, its edges and a small bend on the front side.
- The phone is wrapped in the resulting multi-colored or plain sheet of silicone.
- It needs to be pressed a little into the “dough” to mark the holes for the camera and speaker grille, located on the back side.
- Connectors and control buttons on the side elements of the phone must be marked by running your thumb along the entire perimeter of the phone.
- The silicone should harden. Its readiness time depends on the thickness of the rolled layer and the data provided by the manufacturer.
- It is better to remove excess silicone immediately using a stack or a plastic knife. Without excess material it is easier to form the corners.
Advice! Hardening of the silicone mass can take up to 12 hours. Move the SIM card to another phone or forward calls. Otherwise, the cover will not have a smooth surface.
Return or exchange guarantee
A money-back or exchange guarantee for defective goods can be very useful, most good stores are required by law to adhere to this rule and provide you with such a guarantee for a period of 14 days. However, in the online store site such a guarantee is as much as 25 days!
This is an opportunity to test the product in practice, without risking losing your money.
Please note that unscrupulous sellers also write about this guarantee, but they use free ad services and one-page sites to distribute their goods, since you will not be able to check reviews about such a seller or complain anywhere.
When choosing a reliable store, pay attention to the presence of a real address, reviews using authorization through social networks and high-quality advice on the issue that interests you.
Ask if you can come and see the product at the specified address? If the seller refuses to show you the product and insists on sending it with advance payment or partial payment, he is most likely a scammer.
Our online store also has a channel on YouTube, and you can see what the type of case you are interested in looks like.
How to solve the problem of shrinking the case
If you have already become the owner of a would-be case, first of all you can try to return it back to the store, based on its inconsistency with the specified model. Only if you fail to do this can you proceed with independent procedures and subject the case to various tests. After all, there is nothing left to lose.
What kind of aids for changing sizes are recommended on the Internet: hair dryer, alcohol, freezer, boiling water, acetone, even a microwave oven. We tested, in our opinion, the most adequate method - and we managed to shrink our experimental sample by a few millimeters.
So, for our experiment we needed the cover itself, a stove, a saucepan, and water. We boiled water and lowered the cover into it for 7 minutes. While the cover was cooking, hold it with a spoon so that it does not float up. After undergoing the rejuvenating procedure, the accessory went to cool down. When its temperature dropped to normal, we tried it on our smartphone - the case no longer fell off and fit tightly.
Let us clarify that our case was made of opaque silicone. This method has a very ambiguous effect on transparent cases, turning the transparent material into a matte one. Well, if the color of the case is not important to you, but its functionality is important, this is unlikely to stop you. But, in turn, we warned you. Having also conducted an experiment with several more pads, we came to the conclusion that not all of them reacted with compression to bathing in boiling water. Some remained larger than necessary in size. From this we concluded that this method is not suitable for every case, but you can still change the size of the silicone case. Unfortunately, you can find out whether this method is effective for your case only by conducting a similar experiment yourself.
Comments
✉ EMAIL: Cooperation/Współpraca/Business Inquiries:
Don't know how to make money? Ask me how and I'll tell you
Well, let's try to adjust the case to size? And here you will find even more descriptions and photos
Don't forget about additional savings with purchases on Aliexpress. My choice of proven cashback - from 7 to 18 percent savings on all products from Aliexpress
An affiliate program that helps promote the channel and earn money
Link to the bumper/case this Well that will try the case to fit? And here you will find more descriptions and photos
Don”t forget about additional savings when shopping on Aliexpress. My choice of validated cashback from 7% to 18% savings on all products from Aliexpress
Affiliate program that helps to promote your channel and earn Source youtube.com/watch?v=KuNZYfaDQc8
Video content was added by the user “ Aleksa Onle
” to your video channel for 3 years. ago, it has already been viewed 155,942 times. The video material was liked by 1,179 and disliked by 1,540 website visitors. What do you think about this video for Android? Write below and let's discuss!
This video material for phones, smartphones, tablets and other digital devices can not only be viewed online on the Android.Net website, but also downloaded completely free of charge and without any registration in files: mp4, webm, 3gpp and even mp3. To download files, you just need to click on the “Download” button at the top of the site and move the slider all the way to the right. Do you want more interesting videos from this author? You have the opportunity to watch other videos for Android
from this user, which are also published in the official video channel of the author https://site/s/Channel+Aleksa+Onle, as well as other similar videos related to Android phones, smartphones, tablets and other electronic devices. Our video site has a modern adaptive design that allows you to view videos on any portable electronic devices and on TVs with the “Smart TV” function.
103583
If you notice an error, select a piece of text and press Ctrl+Enter
